Wide Band Oxygen Sensor Controller
The LC-1 Lambda cable is a complete wideband controller built in to a sealed cable. It features the same award-winning patented digital measurement principal found in the LM-1, and includes digital input, output, and 2 user programmable analog outputs.
The LC-1 is more accurate than conventional designs costing many times as much, and its self-calibrating circuitry can compensate for changes in temperature, altitude and sensor condition. The LC-1 is ideal for applications such as Dynos, Data Acquisition, Standalone ECUs, piggyback fuel controllers, OBD-II software or chip programmers, and gauges. With the LC-1, you can add additional wideband channels to your LM-1, convert an existing narrow-band gauge, or add wideband capabilities to your dyno. You can even tune individual cylinders by using multiple LC-1 kits.
Key Features
- Only fully digital wideband controller.
- Auto calibration capability to compensate for changes in temperature, altitude, and sensor condition.
- Two user programmable analog outputs.
- Permanent install applications
- Cost effective individual cylinder tuning.
- Easy to upgrade.
- Includes LogWorks software
|
 |
The LC-1's analog outputs are compatible with dynamometer software, gauges, or virtually any brand of Data Acquisition hardware, such as:
- Accel
- Advanced Racing Technologies
- Advantage Motorsports
- AiM Sports ( MyChron)
- Altronics
- Autometer
- Competition Data Systems
- CORRSYS-DATRON
- Corsa Instruments
- Cygnus Data Star
- DTA Competition Engine Management Systems
- Dynamic Test Systems
- Dynocom
- DYNOmite (Land & Sea)
- EcuTek
- Edelbrock Qwik Data
- EFI Technology
- Electromotive
- Engine Management Systems
- Excalibur Solutions
- Brockway Engineering
|
- Fuel Air Spark Technology (FAST)
- FXL Data
- Haltech Engine Management Systems
- Harrison Engineering
- Holley
- Link ECU
- Microtech
- MoTeC
- Mustang Dynamometer
- Pi Research
- Powertrain Control Solutions
- Powertrain Electronics
- Race Technology
- Racepak
- RPM Performance
- SPA Technique
- Stack
- Stuska Dynamometers
- Superflow
- Traqmate
- Etc...
|
The LC-1 is also a key component of Innovate Motorsports' Modular Tuning System (MTS). Using the LC-1's serial ports you can daisy-chain other Innovate devices such as the XD-16, AuxBox (LMA-3), DL-32, TC-4, and SSI-4.
|
FS3769 |
$199.95

|

Fuel Injectors
These are the ever-popular Bosch 42lb and Siemens 60lb. fuel injectors used on our FocusSport Duratec turbo kits. However, these will also work on many other Ford models and other car makes with proper ECU tuning.
Bosch 42lb - Set of 4 Fuel Injectors - Direct fit for Zetec
(EV1 Connector - Supports up to 260-280 WHP)
|
FSPR6647 |
$174.95

|
Siemens 60lb - Set of 4 Fuel Injectors - Direct fit for Zetec
(EV1 Connector - Supports up to 380-400 WHP)
|
FSPR6660 |
$209.95

|
Siemens 60lb - Set of 4 Fuel Injectors - Direct fit for Duratec
(EV6 Connector - Supports up to 380-400 WHP)
|
FSPR6666 |
$239.95

|

T25/T28 Turbo Discharge Flange
This is the same T25/T28 5 bolt flange that we use on our downpipes for our FocusSport Duratec turbo kits. Made from 304L Stainless Steel with a pocketed design for those wanting to use an internal wastegate.
|
FS090-14 |
$54.95

|

Mini Din 9 Cable
This is the cable for the SCT Xcalibrator 2 needed for datalogging auxiliary signals such as air/fuel, EGT's, & boost level, etc.
|
FSSCTX29 |
$10.00

|

FocusSport Turbo Water Line Kit
Keep your turbo bearings cooler while reducing underhood temperatures. Increases turbo bearing life & reduces engine cool down time between aggressive driving. Highly recommended for any track use or hot weather climates. Install time is 2 hours.
For FS Turbocharger Stage 1/2 Kit
|
FS090-17 |
$89.95

|

Stainless Steel Braided Oil Drain Hose Upgrade Kit
Upgrade your original rubber oil drain hose with this S.S. braided
version. Can be mounted in it's original location or tapped directly into
the oil pan. Comes with all new hardware, gasket, & fittings. Recommended
for any racing or hot weather climates. S.S. braided hose will not require
replacement after every 8,000-10,000 miles like the factory rubber hose
which comes with the FS turbo kit.
Temperature Range -100F to 500F (-73C to 260C) Intermittent Service
Temperature Range -65F to 450F (-54C to 232C) Continuous Service
For FS Turbocharger Stage 1/2 Kit
|
FS090-16 |
$59.95

|

Turbo Oil Drain Hose
The original turbo drain hose must be replaced every 8,000-10,000 miles.
If the oil drain hose is not replaced within the recomended time the hose
may start to leak engine oil.
For FS Turbocharger Stage 1/2 Kit
|
FS090-19 |
$5.95

|
Turbosmart Boost Gate Controller
By far the easiest and most cost-effective way of controlling the amount of pressure going to the wastegate is via a Gated Boost Control Valve. All Turbosmart Gated Boost Controllers are manufactured from high-grade brass and aluminum and are renowned for their easy installation, operation and stability. The extensive range covers all applications; from mild street-tuned engines, to purpose-built race power plants.
-
Set your Boost and forget it
-
Boost is fully adjustable from under the bonnet
-
Detent System for ease of adjustment
-
Gated System to bring boost on faster
-
Can be mounted with an optional mounting bracket Mounting Bracket - BOOST TEE only
-
Anodized billet aluminum
-
Supplied with all mounting hardware
Boost Gate Controller
(Already comes with FS Turbocharger Stage 2 Kit)
|
FS090-30 |
$89.95

|
Aluminum Heat Shield Tubing
Heat protection for your plug wires, hoses, and more. Aluminum heat shield sleeves are made from a composite heat shield material with unlimited uses. This composite material provides abrasion resistance, thermal insulation, and physical containment of hoses and wiring. The material is a combination of aluminum, silica, and stainless steel, which provides a sleeving that is flexible, lightweight, and strong. Install these sleeves on wires or hoses by slitting the material, rather than disconnecting the wire or hose ends. These sleeves can withstand extreme temperatures of 750 degrees F. 3/4" & 1" Diameter are available.
Universal 3/4" Tubing (Sold by the foot)
|
FS090-750 |
$3.95 Ft

|
Universal 1 " Tubing (Sold by the foot)
|
FS090-100 |
$3.95 Ft

|


Diverter Valves
These valves are a great choice
for FocusSport turbo kit owners that plan on exceeding 14 psi.
The Turbosmart Diverter valve is adjustable. Please note that all valves are louder than the Bosch
diverter that is included with the FocusSport turbo kit. Valves come
with a Lifetime Warranty.
Bailey
Polished Silver or Black |
DV30 |
$164.95
 |
VF-Engineering
- Aluminum |
DV/VFRACE |
$149.00
 |
Turbosmart
Black - Adjustable |
FSKTPB25 |
$199.00
 |
Turbosmart adjustable dual port blow off valve / diverter valve |
FSKTDP25 |
$224.00
 |

Wastegate Actuators
Boost can be doubled on these units with addition of boost controller.
Garrett OE GT28R Wastegate Actuator |

FS090-37 |
$39.95
 |
8 PSI Wastegate Actuator for GT28R, GT28RS, GT2871R |

FS090-35 |
$59.95
 |
12-14 PSI Wastegate Actuator for GT28R, GT28RS, GT2871R |

FS090-36 |
$79.95
 |